Light my bricks RGB IR remote control board

This RGB card is a small circuit board with 2 outputs and a built-in IR sensor to remotely control Light my Bricks RGB bit lights and RGB strip lights. (Without IR remote control - this can be purchased separately)
Important Note: This RGB Component is only compatible with other components from the Light my Bricks RGB Range.
This RGB Board is a small circuit board has 2 output ports and contains a built-in IR sensor. It is used to control Light my Bricks RGB Bit Lights and RGB Strip Lights. Simply add this onto your existing light circuit via a normal connecting cable, or connect your power source directly to the IN port (+5V).
Light my Bricks RGB Lights are capable of projecting over 9 different colours and can connect to our RGB Board with its two built-in OUT ports either directly or through our RGB Expansion Board. Set your desired colour or effect via using the RGB Board's accompanying Remote Control.
The default setting on the RGB Board is off even when the other components in your light kit have been turned on.
To control the RGB lights, point the remote control toward the RGB Board and then turn the lights on via the ON button. Choose your desired colour by pressing any of the coloured buttons. You can also control the brightness as well as choose from one of the following effects:
Flash - Flash effect on your chosen colour
Strobe - Will flash quickly while cycling through all the colours
Fade - Will cycle through all the colours 3 seconds at each colour
Smooth - Will cycle through all the colours 7 seconds at each colour
Light My Bricks LEGO Lighting Components provide an easy DIY way for LEGO fans to customize their models using LED lights. With a wide variety of colours, lighting options and effects, anyone can light up their LEGO set.
All Light my Bricks components are plug and play - no electronics knowledge needed.