Futaba Receiver R7003SB 2.4 GHz FASSTest

Small, only 7g light 3 /18 - channel 2.4GHz FASSTest® S.BUS receiver with full range and integrated telemetry transmitter. Super slim for models with narrow hulls. With S.BUS system for up to 18 channels and therefore usable from mini - helicopter to large scale model aircraft. Normal PWM output The outputs of the 3 PWM servo channels can be assigned in 11 groups to the outputs port 1 and 2, whereby output assignment - largely free - can be selected. S.BUS output Up to 18 of the new, programmable S.BUS servos or peripheral devices such as gyros, flybarless systems or speed controllers can be connected directly to this output. - One supply line for all channels. - No cable clutter and less weight. - Additional standard servos can be connected to the receiver via S.BUS PWM adapters. Outputs Switchable to S.BUS and/or S.BUS2 protocol. It couldn't be simpler. High Response Switchable output speed of control pulses for digital servos, 6.3 ms instead of 16 ms, resulting in an even shorter response time. Antenna Diversity The 2-antenna diversity system constantly checks the signal quality of both antenna inputs and switches to the better input signal at lightning speed and without transitions. Telemetry S.BUS2 devices or sensors can be connected via the S.BUS2 connector and up to 32 telemetry data sets can be transmitted. The transmitter integrated in the receiver transmits the telemetry data present at the S.BUS2 port to the FASSTest® transmitter, where it is shown on the display, announced or output acoustically. Alternatively, the data can also be radioed to the separate telemetry box. External voltage measurement When the receiver is connected, data such as, receiver battery voltage, external voltage (up to 70V-DC) and antenna signal strength, i.e. the most important telemetry data, are automatically radioed to the ground. To measure the external voltage (flight battery) the output port 2 is switched from servo operation to voltage measurement, an adapter cable is included. The voltage connection is made via the optional connection cable Extra Voltage (No. F1001100). Power Wide voltage range from 3.7...7.4 V nominal voltage. Note: When using 7.4 LiPo batteries as receiver battery, the connected servos must also have the appropriate voltage rating. The receiver does not have an internal limiter for the HV servo voltage.